Skip to content
4412 Third Avenue, Brooklyn, NY 11232Monday – Friday: 7:00 am – 5:00 pmSince 1986Master Plumber · NY License no. 000000General liability and workers' compensation
1 more license
  • Master Plumber · NY License no. 000000
  • General liability and workers' compensation
No-heat line(718) 555-0103

Brooklyn, New York

Services

Boiler replacement and sizing

A boiler is replaced when repairs stop making sense, and the new one is sized from the radiators in the building.

We measure the radiators, look at the piping and the flue, and write a scope you can show your board. We replace a boiler with the same kind of heat unless there is a reason not to.

Signs you need it

  • Repairs on the same boiler more than once a season

  • A cracked section or a leak in the boiler body

  • A boiler that cannot hold its water level

  • A flue or chimney in poor condition

  • Fuel bills that climb while the building stays cool

  • An insurer or an inspector who has flagged it

Brick chimney with metal flashing on a wood shingle roof under a blue sky

The visit

What happens at the visit

  1. 01

    Step 1: We measure the radiators

    Square feet of cast iron and the length and condition of the pipes, not the label on the old boiler.

  2. 02

    Step 2: We look at the flue and the chimney

    A new boiler may need a liner or a different connection.

  3. 03

    Step 3: You get a written scope

    The boiler, the controls, the piping changes, the permit and who files it, and what is left out.

  4. 04

    Step 4: We schedule around the heat season

    Most replacements happen in the warm months. If the boiler fails in winter, we say how long the building will be without heat.

  5. 05

    Step 5: We install, test and train

    We run the boiler through a cycle, show the owner or the super what to watch, and leave a log for the file.

Cost

What drives the cost

We don't print prices here. These are the things that move the number, and the estimate lists each one that applies.

  • Steam or hot water

    A boiler of the same kind is a smaller job than a conversion, and a conversion may need new radiator valves.

  • Size

    Set by the radiators in the building, not by the old boiler.

  • Controls

    The pressure control, the low-water cutoff and any outdoor sensor.

  • Piping changes

    Near-boiler piping is rebuilt to the maker's drawing.

  • Flue and chimney

    A liner, a new breeching, or a draft control.

  • Permit and filing

    Who files, what it costs, and how long it takes.

  • Old boiler removal

    Rigging it out of the boiler room, and disposal.

Questions

Questions about this work

How long is the building without heat?

It depends on the work and the weather. Your scope says how long, and we try to schedule the shut-off for the warm months.

Will a new boiler fix my cold apartments?

Not by itself. We check the pipes and vents first, so you are not paying for a boiler that leaves the same rooms cold.

Do you replace the whole system?

Only if the pipes and radiators need it. Most steam buildings keep their radiators and mains.

Related

Often part of the same visit

Book a visit or call the office

Tell us the building and what you see. We will call you back to set the visit.